123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

My trailer tire blew out and rubber got caught in the brake caliper, can this be fixed on the roadside?

trailer · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["tire blowout","tire rubber caught in brake caliper"]

Our answer

When a blowout occurs on a trailer equipped with disc brakes, shredded tread can easily wrap around the brake caliper, rotor, ABS sensor wiring, and air lines. A mobile mechanic can typically resolve this on the roadside by safely lifting and securing the axle, removing the wheel assembly, and carefully clearing all debris from the caliper and rotor. First, inspect the area carefully without pulling forcefully on debris, as tangled rubber can damage flexible brake hoses or ABS sensor wires if yanked. Check if the caliper slide pins, pads, or dust shields are damaged, and verify that the air brake lines haven't been torn or kinked by flying rubber. If the caliper is intact, free of debris, and not leaking air or brake fluid, mounting a replacement tire and wheel assembly will get you back on the road. However, if the impact shattered the caliper housing, bent the rotor, damaged the brake chamber, or severed air lines, the brake component must be repaired or replaced on-site before moving the vehicle safely.

What the technician found

Driver reported a blowout where tire rubber got caught inside the trailer brake caliper. Cause not confirmed on the call.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request