123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

Call (855) 450-1212Request diagnostics

What was reported

["air brake system issue at dash","primary and secondary air supply reaching dash valve"]

Our answer

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve manifold manages air distribution to the parking and trailer air brake circuits. When internal O-rings or shuttle valves wear down, high-pressure air bypasses internal chambers and constantly exhausts under the dashboard or prevents the parking brakes from releasing cleanly.

A driver can safely perform a preliminary check by charging the air tanks to governor cutoff, turning off the engine, and listening closely under the lower dash panel for air escaping around the push-pull knobs or exhaust ports. Inspecting physical air lines leading into the back of the dash panel can confirm that both primary and secondary supply pressures are arriving as expected. If supply pressure is verified but air is escaping through the valve's exhaust port, the valve assembly requires replacement. Replacing a dash valve involves bleeding all air tanks completely, removing dash panel covers, marking each air line to ensure correct port orientation, and installing a new valve module before performing a complete leak and pop-out pressure test.

What the technician found

Checked primary and secondary air supply lines leading to the dash brake control valve; verified supply pressure was present on both lines, identifying a faulty dash valve that needed replacement.

How it ended

fixed on site

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request