123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why is my Hino truck running very slow with fault codes P2002 and P203F?

Hino · Farmington, · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["engine codes P2002 and P203F","check engine light on","truck going very slow","loss of engine power","engine in derate"]

Our answer

Fault code P2002 indicates that the Diesel Particulate Filter (DPF) efficiency has fallen below threshold due to excessive soot accumulation, while P203F points to an issue within the DEF reductant tank system or level sensor. When the engine control module detects severe exhaust restriction or DEF system faults, it places the truck into a safety derate mode, heavily restricting power and vehicle speed to prevent further engine or aftertreatment damage.

First, check your DEF fluid level and quality to ensure the tank is filled with clean diesel exhaust fluid. Inspect the exhaust system and aftertreatment sensors for any visible damage or obvious exhaust leaks. If the dash permits, try initiating a parked forced DPF regeneration.

If the DPF is clogged beyond what a standard parked regen can clear, clearing the codes with a scan tool will only yield brief relief before the truck derates again. A technician can hook up diagnostic software to monitor soot levels and differential pressure. When the filter becomes heavily packed or face-plugged, the truck needs to be brought or towed to a service facility to have the DPF removed for specialized thermal cleaning, baking, or replacement.

What the technician found

Engine active codes P2002 (DPF efficiency below threshold) and P203F (DEF reductant level/system fault) causing the truck to go into engine derate. Dispatch advised that the DPF filter is likely clogged and requires off-site thermal cleaning or dealer service.

How it ended

customer declined

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request