123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why does my Freightliner start up but shut right off when I press the gas pedal?

Freightliner · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["engine starts then stalls","won't accept throttle","ran low or out of fuel"]

Our answer

When a diesel engine like a Freightliner runs low or out of fuel, air gets drawn into the fuel lines, fuel filter housing, and rail. Adding fuel to the tank allows the engine to start briefly on residual priming, but trapped air prevents the high-pressure pump from maintaining flow when throttle is applied, causing the engine to stall immediately. Running a tank dry also frequently pulls bottom-tank sediment straight into the primary and secondary fuel filters, clogging them and starving the engine under load. First, check your fuel water separator bowl for sediment or air bubbles. If your rig has a manual priming pump on the filter housing, pump it repeatedly until you feel solid resistance to help force air out of the fuel lines. If priming the system does not solve the issue, a mobile diesel mechanic should be called to replace the fuel filters, purge remaining air, test fuel delivery pressure, and check for ECM active codes related to throttle position or fuel pressure sensors.

What the technician found

Engine starts after adding fuel, but will not respond to throttle and stalls immediately. Cause not confirmed on the call.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request