123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why is my Cummins semi truck building air at the compressor but not sending air to the tanks?

Cummins engine · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["truck not building air pressure in tanks","air building at compressor but not reaching tank","suspected air dryer failure"]

Our answer

When an engine compressor generates air but pressure never reaches the supply tanks, the issue typically lies within the air dryer assembly or its control circuit. The most common cause is a stuck or damaged air dryer purge valve that remains open, continuously venting compressor output into the atmosphere rather than routing it to the air tanks. Other possibilities include a heavily contaminated or clogged desiccant cartridge, a stuck internal check valve in the dryer body, a faulty air governor signal line holding the compressor unloader open, or heavy carbon restriction inside the discharge line. As a driver, you can perform a quick check by listening near the exhaust port of the air dryer while the engine runs. If you hear a constant, loud hiss of escaping air, the purge valve assembly or governor signal is stuck. Also visually inspect the line between the compressor and dryer for cracks, leaks, or extreme heat damage. Because servicing air system components directly impacts your vehicle air brakes, a technician should physically inspect the unit to rebuild the purge valve or replace the complete air dryer assembly on site.

What the technician found

Driver checked the discharge line between the compressor and the air dryer over the phone and reported it intact. Cause not confirmed on the call.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request