123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why is coolant leaking heavily from the back of my truck engine?

2026-11

Call (855) 450-1212Request diagnostics

What was reported

["antifreeze leak behind engine","suspected burst coolant line"]

Our answer

Coolant leaking from the back of a heavy-duty diesel engine is typically caused by a blown heater hose, a failed EGR cooler coolant line, damaged turbocharger coolant lines, or a leaking rear engine cover gasket or freeze plug. Because space behind the engine bay is tight, vibration and high thermal cycling can cause rubber coolant hoses to rub against the firewall or metal brackets until they split and dump antifreeze quickly.

If you suspect a coolant line leak, turn off the engine immediately to prevent severe overheating and cylinder head damage. Never attempt to remove a radiator cap or hot coolant cap while the system is pressurized. Once the engine cools down, perform a visual inspection with a flashlight around the rear of the cylinder head, firewall heater lines, and EGR cooler plumbing for visible wetness, splits, or dripping coolant. Check your coolant reservoir level. If a hose has split, a mobile mechanic can often bypass or splice the damaged section on site and pressure-test the cooling system before refilling it with proper antifreeze. If the leak is from a hard-to-reach rear structure component or freeze plug, towing to a shop may be required.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request