123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why are my semi truck brakes locking up while my ABS light is on?

Etna, · I-70 · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["brakes locking up","ABS light on"]

Our answer

When semi truck brakes lock up alongside an illuminated ABS light, the issue usually stems from either a pneumatic air system failure or an electronic ABS control fault. The most common cause is a compromised air line, fitting, or damaged brake chamber, which prevents proper air supply from releasing the spring brakes. A failed relay valve or stuck brake shoe can also prevent releasing pressure. Additionally, an active ABS fault—such as a failed wheel speed sensor or damaged wiring harness—can trigger electronic brake control valves to misbehave or lock up a wheel position. Drivers can safely perform a quick visual inspection starting at the gladhands and supply lines to ensure hoses are properly connected and not kinked, pinched, or severely leaking. Check your dash air gauges to confirm primary and secondary tanks are building and holding full pressure. Inspect the brake chambers and linkage for visible damage or mechanical bind. If air pressure is dropping rapidly, lines are ruptured, or the brakes remain locked despite adequate air pressure, do not attempt to force the vehicle to move. A mobile diesel technician should perform diagnostic pressure tests and ABS fault scans on site to safely resolve the lockup.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request