123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

Why is my 2014 box truck showing a red dash light and losing driving power?

2014 box truck · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["red light on dashboard","engine lost power","won't drive fast","derate mode"]

Our answer

A red warning light accompanied by a sudden loss of engine power usually indicates the truck has gone into derate mode to protect critical engine or emissions components. Common causes include DPF system restrictions, bad DEF quality or pressure sensors, EGR valve failures, or severe coolant/oil temperature or pressure alerts. When an automatic box truck enters derate, the engine control module limits throttle response and vehicle speed so you can safely pull off the road without destroying the engine. First, check your dash gauges for low oil pressure, high coolant temperature, or low DEF fluid levels. Inspect the dash for specific fault icons like a DPF full or stop engine light. If temperatures and fluid levels are normal but the red light persists and speed is limited, avoid driving long distances in derate mode as it can cause further damage. A technician needs to connect heavy-duty diagnostic software to read active fault codes, evaluate aftertreatment sensors, and determine if a forced DPF regen or sensor replacement is required.

What the technician found

Cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

Why is my semi truck air leaking or failing at the dash valve when both supply lines have pressure?

2026-11

When both primary and secondary air supply lines deliver full pressure up to the dash control valve but the system fails to hold pressure or operate properly, the internal seals within the dash control valve assembly have likely degraded. The dash brake valve…

What should I do if my air lines wrapped around my tire and snapped the air valve off the back of the cab?

2026-11

When pigtails or air hoses drop and catch on a spinning drive tire or driveshaft, the extreme force will yank the hoses and snap whatever mounting hardware or valve assembly secures them to the back of the tractor cab. Replacing just the red and blue coiled s…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request