Fort St. John, BC · 2026-11
Call (855) 450-1212Request diagnostics["auxiliary air showing 90 PSI","secondary air showing 7 PSI","not building air properly"]
When a semi-truck shows normal auxiliary air pressure around 90 PSI while secondary air drops down to 7 PSI and fails to build, the air distribution system is isolating or losing air in the secondary circuit. The primary suspect is a faulty pressure protection valve that is stuck closed or restricting airflow to the secondary system. Another common cause is a severe air leak specifically in the secondary air circuit, such as a ruptured air line, leaking brake chamber diaphragm, stuck open drain valve, or faulty air dryer purge valve. If the air compressor or governor were failing completely, both main tanks would typically drop equally.
To safely check this on the roadside, start by performing a walkaround to listen for audible air leaks around the secondary air tank, gladhands, brake chambers, and air dryer. Make sure the manual drain valves on all air tanks are completely closed. Check your dash gauges to confirm if the primary system is holding pressure.
Because secondary air supplies critical braking components, a secondary system stuck at 7 PSI means your spring brakes will remain locked and the vehicle cannot be safely driven. You will need a mobile heavy-duty technician to diagnose the air circuit and repair the leak or replace the protection valve on site.
Checked air system readings reported by driver; auxiliary tank was holding 90 PSI while secondary tank dropped to 7 PSI and failed to build pressure. Cause not confirmed on the call.
unknown
Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.
When a radiator hose comes loose or leaks coolant on a Detroit engine, the ECM detects rapid coolant loss and high engine temperatures. To protect the engine from severe internal damage like blown head gaskets or warped heads, the ECM triggers a derate into l…
When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…
When a Kenworth builds full air pressure but the parking brakes refuse to release, the issue usually stems from a restriction in the spring brake release circuit, a faulty dash brake control valve, or a stuck relay valve. If a valve was recently serviced or r…
When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…
123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com
Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.