123 TRUCK DIAGNOSTICS(515) 200-7810 · Mobile diagnostics 24/7

Why is my semi truck constantly losing air out of the air dryer purge valve while parked?

Clive, IA · I-80 · 2026-11

Call (515) 200-7810Request diagnostics

What was reported

["air constantly coming out of the air dryer","unable to build or hold air pressure due to dryer leak"]

Our answer

When a semi truck constantly vents air out of the air dryer purge valve, the most common issue is a stuck open purge valve or a degraded internal seal inside the air dryer assembly. Oil, moisture, and sludge buildup from the air compressor can contaminate internal components, preventing the valve from seating properly after a purge cycle. Another cause is a faulty air compressor governor or a damaged control line that continuously sends pilot air to the purge valve. If you hear air constantly escaping from the dryer, check your air pressure gauges to see if the system can build pressure. You can carefully tap the side of the purge valve housing with a small rubber mallet or wrench handle to see if a stuck valve unseats and closes. Inspect the signal line leading from the governor to the air dryer for leaks or damage. If air continues to bleed off and prevents your brake system from maintaining pressure, stop driving immediately. A mobile technician will need to service the purge valve assembly or replace the air dryer cartridge on site.

What the technician found

Driver reported air continuously exhausting from the air dryer assembly. Dispatcher confirmed replacement air dryer parts were available on the service truck to dispatch out.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why is my Kenworth with a Cummins engine not building any air pressure?

Kenworth Cummins engine · 2026-11

When a Kenworth truck equipped with a Cummins engine fails to build any air pressure in both primary and secondary tanks without an obvious audible air leak, the issue usually stems from the air supply system before the reservoir distribution. The most common…

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why won't my 2019 Kenworth release the parking brakes even though the truck is building full air pressure?

2019 Kenworth · Richmond, CA · 2026-11

When a Kenworth builds full air pressure but the parking brakes refuse to release, the issue usually stems from a restriction in the spring brake release circuit, a faulty dash brake control valve, or a stuck relay valve. If a valve was recently serviced or r…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (515) 200-7810 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (515) 200-7810Request