123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

What causes a short pressure hose to leak near the engine on a Kenworth and how dangerous are loose front end bolts after a repair?

Kenworth · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["leaking engine hose","wet trail under truck","loose screws after kingpin repair"]

Our answer

A wet trail under your engine combined with a leaking short pressure hose usually points to age-related degradation, thermal fatigue, or constant vibration loosening clamp connections. Short high-temperature hoses located near the engine or fan hub assembly carry pressurized coolant or oil and can split under heavy load. If you notice fluid pooling, inspect the hose for cracking, swelling, or soft spots, and verify whether the hose clamp has backed off or cut into the rubber. When replacing special heat-resistant hoses, securing the exact inner diameter and length is critical to prevent kinked lines or renewed leaks. Loose fasteners on the front axle or steering knuckle after a recent kingpin service are a major safety hazard. Un-torqued bolts can cause severe play, erratic steering, accelerated tire wear, or catastrophic component failure on the highway. If you discover loose hardware following front-end service, do not continue driving until every fastener is torqued to manufacturer specifications by a qualified heavy-duty technician.

What the technician found

Reviewed customer photos showing a 5 to 6 inch heat-resistant pressure hose leaking near the engine and loose fasteners left untightened following a recent kingpin replacement.

How it ended

parts needed

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why is my yellow dashboard parking brake valve broken and leaking air?

Richmond, · 2026-11

When a semi-truck yellow dashboard valve breaks or fails to push in and hold, it usually points to an internal mechanical failure within the push-pull valve manifold or severe air leakage across the internal valve seals. If the yellow parking brake valve snap…

Why does my bucket truck auxiliary switch keep failing after repairing the wires?

International bucket truck · 2026-11

When auxiliary switches or equipment controls fail intermittently on specialty utility and bucket trucks, electrical harness damage is the primary culprit. On equipment mounted over swivel mechanisms or moving seats, continuous articulation, pinching, and str…

My truck is showing a water in fuel fault and wiring code, is it safe to drive to a shop?

auto carrier · 2026-11

When a water-in-fuel indicator light turns on or logs a fault code, it typically signals that water has accumulated in the fuel filter separator bowl, or there is an electrical issue in the sensor circuit. First, check the fuel-water separator bowl on your en…

My Volvo 670 won't start after the ignition was left on and drained the batteries, what should I check?

Volvo 670 · 2026-11

When a heavy-duty truck like a Volvo 670 won't crank after the key or accessories were left on, the most common issue is simple battery depletion. Leaving the ignition switched on powers up the main ECM, dash lights, and cab electronics, which quickly drains …

Why does my Volvo D13 engine start, run for two minutes, and then shut off?

Volvo D13 · 2026-11

When a Volvo D13 engine starts up, runs for roughly two minutes, and then dies, it is usually caused by fuel starvation or air entering the fuel supply system. A broken or cracked diesel fuel line allows air to get drawn into the low-pressure fuel circuit, re…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request