123 TRUCK DIAGNOSTICS(855) 450-1212 · Mobile diagnostics 24/7

What should I do if the coolant line coming off my Kenworth expansion tank is leaking?

Kenworth · Drumbo, ON · Hwy 401 · 2026-11

Call (855) 450-1212Request diagnostics

What was reported

["coolant line leaking","damaged line coming off reservoir"]

Our answer

Coolant lines coming off a Kenworth expansion tank or overflow reservoir frequently fail due to constant engine vibration, thermal expansion, and aging rubber or plastic fittings. The most common causes are a split hose end, a cracked plastic fitting at the reservoir neck, or a loose hose clamp. If you notice coolant leaking from this upper overflow hose, pull over safely and let the engine cool down completely before inspecting it. Never attempt to remove or adjust coolant lines or cap while the system is hot and pressurized. Once cool, inspect the hose end for splits. If there is sufficient slack in the hose, you can sometimes cut off the damaged inch of rubber and re-clamp it tightly over the nipple as a temporary fix to reach safety. However, if the plastic nipple on the surge tank itself is cracked or broken off, the reservoir or fitting must be replaced. A mobile diesel technician can pressure test the cooling system, replace split silicon or rubber hoses, and replenish the coolant safely on site.

What the technician found

Coolant line coming off the reservoir was leaking or damaged.

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why won't my 2019 Kenworth release the parking brakes even though the truck is building full air pressure?

2019 Kenworth · Richmond, CA · 2026-11

When a Kenworth builds full air pressure but the parking brakes refuse to release, the issue usually stems from a restriction in the spring brake release circuit, a faulty dash brake control valve, or a stuck relay valve. If a valve was recently serviced or r…

Why are my semi truck parking and trailer brake valves refusing to release when I have plenty of air pressure?

2026-11

When your semi-truck parking and trailer brake control valves won't release despite showing full air pressure on your dash gauges, the issue is often related to a faulty valve assembly, line restriction, or mechanical binding. The primary culprit is usually a…

Why does my Kenworth yellow parking brake knob have no air supply while the red trailer knob works?

Kenworth · 2026-11

When a Kenworth trailer knob charges properly but the yellow parking brake knob has no air supply, the issue typically points to a failed dash push-pull control valve block, an internal manifold seal failure, or a disconnected supply line behind the dashboard…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (855) 450-1212 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (855) 450-1212Request