123 TRUCK DIAGNOSTICS(352) 325-4389 · Mobile diagnostics 24/7

Why is air continuously blowing out of the bottom of my truck air dryer purge valve?

2016 Freightliner Cascadia Detroit DD15 · Vero Beach, FL · 2026-11

Call (352) 325-4389Request diagnostics

What was reported

["air dryer leaking from bottom","air blowing out of purge valve","air system leaking pressure"]

Our answer

When air continuously leaks from the bottom purge valve of a heavy-duty truck air dryer, the most common culprit is a worn or stuck purge valve seal inside the air dryer assembly. Over time, oil carryover from the air compressor or carbon and desiccant debris can foul the purge valve mechanism, preventing it from seating fully after the compressor unloads. Another potential cause is a malfunctioning air governor or a pinched signal line keeping continuous control pressure on the purge valve circuit.

Drivers can safely check a couple of things before calling for service. Observe your primary and secondary air gauges to see if the truck can build and maintain normal governor cut-out pressure. You can also inspect the governor signal hose for damage. Gently tapping the purge valve body with a light tool can sometimes temporarily seat a stuck valve, but it will not fix an underlying mechanical failure.

If air exhausts continuously and prevents the brake system from reaching proper operating pressure, do not drive the vehicle. A professional technician will need to service the system by replacing the purge valve cartridge kit or installing a complete replacement air dryer assembly.

What the technician found

Air dryer purge valve continuously exhaust leaking air from the bottom port on a 2016 Freightliner Cascadia DD15.

How it ended

parts needed

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why did my 2009 Peterbilt 365 with a CAT C13 engine die while driving and now cranks but won't start?

2009 Peterbilt 365 CAT C13 · Pensacola, FL · 2026-11

When a CAT C13 engine in a Peterbilt dies suddenly while operating and cranks continuously without starting, the issue usually stems from a loss of fuel pressure or electrical control to the injectors. First, check your fuel supply and filters. Debris or heav…

Why does my 2009 Peterbilt with a C13 engine crank but refuse to start after shutting off while driving?

2009 Peterbilt C13 · Pensacola, FL · 2026-11

When a Caterpillar C13 engine in a Peterbilt cranks normally but will not fire after suddenly dying on the road, the issue usually stems from fuel delivery failure, electrical supply loss to the engine control module (ECM), or critical sensor failure. Start b…

Why won't my Kenworth parking brake valve push in to release the brakes when I have full air pressure?

Kenworth · Richmond, · 2026-11

When a yellow parking brake valve will not push in or release the brakes despite having full system air pressure, the issue often stems from a faulty dash control valve, a bad inversion valve, or a stuck spring brake relay valve. Since the truck recently came…

Why won't my 2019 Kenworth release the parking brakes even though the truck is building full air pressure?

2019 Kenworth · Richmond, CA · 2026-11

When a Kenworth builds full air pressure but the parking brakes refuse to release, the issue usually stems from a restriction in the spring brake release circuit, a faulty dash brake control valve, or a stuck relay valve. If a valve was recently serviced or r…

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (352) 325-4389 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (352) 325-4389Request