123 TRUCK DIAGNOSTICS(419) 982-2897 · Mobile diagnostics 24/7

Why is my 2014 Volvo D13 losing air and not building pressure?

2014 Volvo D13 · Austinburg, OH · I-90 · 2026-11

Call (419) 982-2897Request diagnostics

What was reported

["air leak","won't build air pressure","losing air fast when brakes released"]

Our answer

When a Volvo D13 engine won't build air pressure beyond a low level, the most common culprit is a sticking air dryer purge valve or a failing air governor that continuously exhausts air. Another frequent issue is a leak in the trailer supply system, such as a damaged gladhand seal, a leaking trailer brake chamber diaphragm, or a faulty tractor protection valve that dumps air whenever the parking or trailer brake valve is pushed in. Additionally, a failed unloader line from the compressor or a leaking air tank drain valve can cause rapid pressure loss.

Drivers can safely troubleshoot by parking on flat ground with wheel chocks set. Start the engine, listen around the air dryer under the cab to see if air is constantly blowing out the bottom exhaust port, and inspect gladhand rubber seals for tears. Spraying soapy water around brake chambers, air dryer fittings, and tractor-trailer lines helps reveal silent leaks. If the truck cannot build enough pressure to safely release the parking brakes or maintain at least 90 PSI while running, do not attempt to drive. Call a mobile diesel mechanic to diagnose unloader valves, air governors, or valve assemblies.

What the technician found

Driver sprayed soapy water under the truck but could not locate the leak; cause not confirmed on the call

How it ended

unknown

More real calls

Written up from real calls to our dispatch line. Names, phone numbers and exact locations are left out.

Why is air severely leaking from my brake chamber area or brake fitting line?

East Liverpool, OH · 2026-11

A severe air leak coming from the brake chamber area is a critical issue that prevents the truck's air brake system from building or holding pressure. The most common cause is a failed internal diaphragm or torn seal inside the spring brake or service chamber…

I bought a new starter for my 2020 Volvo semi truck, can a mobile mechanic install it roadside?

2020 Volvo · Whitehall, OH · 2026-11

When a heavy-duty truck like a 2020 Volvo fails to start, a faulty starter motor, failed starter solenoid, loose ground cable, or discharged batteries are the primary culprits. If you turn the key or push the start button and hear only a single heavy click, r…

Why is coolant leaking from the bottom radiator hose metal line on my 2013 Kenworth with a Cummins engine?

2013 Kenworth Cummins · London, OH · 2026-11

A coolant leak around the lower radiator hose or metal coolant line on a 2013 Kenworth with a Cummins engine is often caused by severe vibration wear, corrosion, or a compromised hose clamp. Over time, metal coolant pipes can rub against surrounding brackets,…

What should I do if my Western Star stalls from a clogged fuel filter?

Western Star · South Vienna, OH · 2026-11

A clogged fuel filter on a heavy-duty truck like a Western Star often causes loss of engine power, rough idling, hard starting, or stalling under load. The most common cause is severe dirt, debris, or paraffin wax buildup restricting fuel flow through the pri…

Why is my 2013 Kenworth leaking coolant from the bottom metal line?

2013 Kenworth Cummins · London, OH · 2026-11

On a 2013 Kenworth equipped with a Cummins engine, a coolant leak coming from a bottom metal coolant pipe or hard line is typically caused by rust corrosion, cracking from engine vibration, or failure of the O-ring seal where the tube inserts into the engine …

All real calls

123 Truck Repair is a service of MTS Mobile Truck Repair Service LLC, dispatching mobile mechanics, heavy-duty shops and wreckers across the United States and Canada, 24/7. · (419) 982-2897 · Request a quote · Local numbers · Real calls · mtstruckservice.com

Engine and truck brand names are used only to describe what we diagnose. We are an independent service, not affiliated with any manufacturer.

Call (419) 982-2897Request